Project
Suite Kitchen & Bath Refresh
Kitchen and bathroom refresh work inside occupied residential buildings, where the finish has to hold up to daily use from day one.
- Category
- Interior
- Location
- Toronto, ON
NotePhotography is Pinnacle’s own work on this type of project. The written details below are drafts awaiting client confirmation.
The Challenge
Where we started.
Kitchens and bathrooms are the two rooms a tenant or buyer inspects closely, and they are the hardest surfaces to finish well: moisture, grease, tile transitions and cabinetry that was never quite square.
Scope
- Degreasing, deglossing and substrate repair before any coating
- Cabinet and millwork refinishing
- Moisture-appropriate products in bathrooms and wet areas
- Tile, tub surround and transition detailing
- Hardware removal, protection and refit
The Solution
How we ran it.
Preparation is the majority of the work. Surfaces are cleaned and deglossed properly so coatings bond, moisture-rated products are used where they belong, and hardware comes off rather than being cut around.
Results
- Cabinetry finished with clean, even coverage
- Wet areas coated with moisture-appropriate products
- Sharp transitions at tile, trim and hardware
Gallery
Project detail.
Start a Project
Planning something similar?
Tell us about your interior project. We will walk the site, document the conditions and come back with a scope you can actually price against.